Drive Select Switch; Headlight Switch - Arctic Cat 2015 WILDCAT TRAIL/XT Operator's Manual

Drive Select Switch

This switch allows the operator to oper-
ate the vehicle in either two-wheel drive
(rear wheels) or four-wheel drive (all
wheels) as well as mechanically lock the
differential to apply equal power to both
front wheels. For normal riding on flat,
dry, hard surfaces, two-wheel drive
should be sufficient. In situations when
additional traction is necessary, four-
wheel drive would be the desired choice.
To select 2WD, depress the bottom of the
switch. To select 4WD, move the switch
to the middle position. To engage the dif-
ferential lock, slide the switch latch
slightly downward while pressing the top
of the switch forward.
CAUTION
Do not engage or disengage the front
differential while the vehicle is mov-
ing.

NOTE: When the differential lock
is engaged, the LOCK icon will be
illuminated on the LCD.
26
The differential lock is intended for use
where minimum traction is available.
NEVER EXCEED 10 MPH (16 kph) with
the front differential lock engaged.
Maneuverability and handling charac-
teristics will differ with the differential
lock engaged. Control loss can result
in serious injury or death.
Foot Brake
WT018A
The foot brake is the only service brake,
and it should be applied whenever brak-
ing is needed. Apply the brake by press-
ing the brake pedal down.
Steering Wheel Tilt Lever
Pull on the lever located on the steering
column and move the steering wheel to
the desired position; then release the
lever and make sure the steering wheel
locks securely.
Make sure the steering wheel is locked
securely in place before moving the
vehicle, or steering wheel movement
WT018B
could occur causing loss of control.

Headlight Switch

! WARNING
! WARNING
WT002A
WT018C