Hydraulic Brake; Brake Fluid - Arctic Cat 2015 WILDCAT TRAIL/XT Operator's Manual

CAUTION
Do not over-fill the engine with oil.
Always make sure that the oil level is
not above the upper mark.
12. Inspect the area around the drain plug
and oil filter for leaks.
Front Differential/
Transaxle Lubricant
(Inspecting/Changing)
Inspect and change the lubricant in each
according to the Maintenance Schedule.
When changing the lubricant, use the
appropriate lubricant and use the follow-
ing procedure.
1. Place the vehicle on level ground;
then remove the fill plugs.
Transaxle
2. Drain the oil into a drain pan by
removing the drain plugs.
Inspect the oil for any signs of metal fil-
ings or water. If found, take the vehicle
to an authorized Arctic Cat dealer for
servicing.

Hydraulic Brake

Be sure to inspect the brakes before
each use. Always maintain brakes
according to the Maintenance Schedule.

Brake Fluid

WT041A
WT025A

located on top of the master cylin-
der above and to the rear of the
front left wheel.
FRONT
CF107A
3. After the oil has been drained, install
the drain plugs and tighten to 45 in.-lb
(front) and 18 ft-lb (rear).
CAUTION
4. Pour recommended quantity and type
of oil into each fill hole.
5. Install the fill plugs and tighten to 16
ft-lb (front) or 18 ft-lb (rear).
! WARNING
1. With the vehicle level and the tires
properly inflated, check the brake
fluid level in the brake fluid reservoir.
The fluid level must be maintained
between the MAX and MIN level
marks. If the level in the reservoir is
low, add DOT 4 brake fluid.
NOTE: The brake fluid reservoir is
2. Press the brake pedal several times to
check for firmness.
3. If the pedal is not firm, the system
must be bled.
WT012A
41