Arctic Cat 2015 WILDCAT TRAIL/XT Operator's Manual page 46

6. If using the CTEK Multi US 800,
there are no further buttons to push. If
using the CTEK Multi US 3300, press
the Mode button (A) at the left of the
charger until the Maintenance Charge
Icon (B) at the bottom illuminates.
The Normal Charge Indicator (C)
should illuminate on the upper por-
tion of the battery charger.

NOTE: The
will charge the battery to 95%
capacity at which time the Mainte-
nance Charge Indicator (D) will illu-
minate and the maintainer/charger
will change to pulse/float mainte-
nance. If the battery falls below 12.9
DC volts, the charger will automati-
cally start again at the first step of
the charge sequence.

NOTE: Not using a battery char-
ger with the proper float mainte-
nance will damage the battery if
connected over extended periods.
Charging

NOTE: Arctic Cat recommends
the use of the CTEK Multi US 800 or
the CTEK Multi US 3300 for battery
maintenance charging.
44
maintainer/charger
3300A
1. Be sure the battery and terminals
have been cleaned with a baking soda
and water solution.
2. Be sure charger and battery are in a
well-ventilated area and ensure battery
charger cables will not contact any bat-
tery acid. Be sure charger is unplugged
from 110-volt electrical outlet.
3. Connect the red terminal lead from
the charger to the positive terminal of
the battery; then connect the black
terminal lead of the charger to the
negative terminal of the battery.
4. Plug the charger into a 110-volt elec-
trical outlet.
5. Using the Mode button (A) on the left
side of the charger, select the Normal
Charge Icon (E). The Normal Charge
800E
Indicator (C) should illuminate on the
upper left portion of the charger.
6. The battery will charge to 95% of its
capacity at which time the Maintenance
Charge Indicator (D) will illuminate.

NOTE: For optimal charge and per-
formance, leave the charger con-
nected to the battery for a minimum 1
hour after the Maintenance Charge
Indicator (D) illuminates. If the bat-
tery becomes hot to the touch, stop
charging. Resume after it has cooled.
7. Once the battery has reached full
charge, unplug the charger from the
110-volt electrical outlet.

NOTE: If, after charging, the bat-
tery does not perform to operator
expectations, bring the battery to
an authorized Arctic Cat dealer for
further troubleshooting.
Jump-Starting

NOTE: Arctic Cat does not recom-
mend jump-starting a vehicle with a
dead battery but rather to remove the
battery, service it, and correctly charge
it; however, in an emergency, it may be
necessary to jump-start a vehicle. If so,
use the following procedure to carefully
and safely complete this procedure.