S-Registers - US Robotics 56K Series Manual

S-Registers

To change a setting, use the ATSr=n command, where r is the register and n is a
decimal value from 0 − 255 (unless otherwise indicated).
Register Default
S0 0
S1 0
S2 43
S3 13
S4 10
S5 8
78
Function
Sets the number of rings on which to answer in Auto Answer Mode
When set to 0, Auto Answer is disabled
Counts and stores the number of rings from an incoming call
S0 must be greater than 0
Stores the ASCII decimal code for the escape code character
Default character is +
A value of 128 – 255 disables the escape code
Stores the ASCII code for the Carriage Return character
Valid range is 0 – 127
Stores the ASCII decimal code for the Line Feed character
Valid range is 0 – 127
Stores the ASCII decimal code for the Backspace character. A value of
128−255 disables the Backspace key's delete function