Table of Contents
Advertisement
Installing Modem Drivers with
Windows NT 4.0 without PNP
Enabled
After installing the modem, turn on
1.
your Windows NT workstation.
Insert the installation disk into the
2.
disk drive, or CD-ROM into the CD-
ROM drive.
Click Start and select Run.
3.
Type A:\Setup (if using a diskette)
4.
or D:\Setup (if using a CD-ROM)
and click OK.
When the Setup program starts, click
5.
Install.
20
The resource page contains the
6.
configuration information of your
modem in Windows NT. COM port,
I/O address, and Interrupt Request
Line are the three resources that may
require adjustment.
The Setup program should have
detected available resources and
entered them. If you want to use
other settings, change them now.
When this is complete, click OK.
7.
Please select the relevant country
8.
followed by OK.
Remove the installation disk or CD-
9.
ROM from the appropriate drive and
click Yes to restart the computer.
Advertisement
Table of Contents
