S-Registers - US Robotics 005689-03 Manual

S-Registers

S-Registers
To change a setting, use the ATSr=n command, where r is the register and n is a decimal value from 0
255 (unless otherwise indicated).
Register Default
S0 0
S1 0
S2 43
S3 13
S4 10
S5 8
S6 2
S7 60
S8 2
Function
Sets the number of rings on which to answer in Auto Answer Mode. When set to 0, Auto
Answer is disabled.
Counts and stores the number of rings from an incoming call. (S0 must be greater than 0.)
Stores the ASCII decimal code for the escape code character. Default character is +. A
value of 128–255 disables the escape code.
Stores the ASCII code for the Carriage Return character. Valid range is 0–127.
Stores the ASCII decimal code for the Line Feed character. Valid range is 0–127.
Stores the ASCII decimal code for the Backspace character. A value of 128 255 disables
the Backspace key's delete function.
Sets the number of seconds the modem waits before dialing. If Xn is set to X2 or X4, this is
the time-out length if there isn't a dial tone.
Sets the number of seconds the modem waits for a carrier. May be set for much longer
duration if, for example, the modem is originating an international connection.
Sets the duration, in seconds, for the pause (,) option in the Dial command.
49