Table of Contents
Advertisement
Call redial
Auto call redial:
If it was not possible for your fax message to be sent, this may be due to various reasons (please read
page
143). One reason may be that the other fax machine is busy. In this case, it would make sense to call
your partner again at a later time. This is done automatically by your fax; it attempts to send the fax message
again approx. every 3 minutes.
You are able to individually set the period between the call redial attempts and also the number of redial
attempts (see
page
Manual call redial:
If the memory contains a job which you wish to redial immediately, you can select this job and manually select
the redial procedure (see diagram).
• Manual call redial does not have any influence on the preset number of call redial attempts (see
REDIAL
PAUSE
START
107).
15-MAR-00 WED
RESIDUAL MEMORY 77%
REDIAL:
[ENTER]:START
[ ]:PREVIOUS SCREEN
[ ]:NEXT SCREEN
after 5 seconds
SINGLE TRANSMIT
TOSHIBA EUROPA
15-03-00
19:33
FILE NBR =
REDIAL
NUMBER NOT LISTED
Manual call redial (from memory)
19:56
Standby mode
Requirement:
There must be at least one job which has
already been dialled and not transmitted.
Press the REDIAL/PAUSE key
Make your selection
for selecting the required job*
The first available job is displayed.
Please refer to
format
008
Select the job which you want to redial.
confirm with START
The job is carried out again.
*) If there is no job available for the redial
facility, the machine displays the
following message:
page
107).
page 62
for details of the job
59
Advertisement
Table of Contents
