Table of Contents
Advertisement
Transmission options, send after scan
The default setting for the fax machine causes the fax machine to commence dialling immediately after
pressing the START button for a scan job. In the case of extensive fax jobs, this can result in the page number
descriptor in the TX header on the first few pages being incomplete. This in turn results in a memory overflow,
the transmission is interrupted and the document part waiting in memory is deleted. This prevents the
document feed becoming jammed.
If an extensive document is to be faxed, the basic settings should be adjusted temporarily. In this context,
transmission is only commenced after the entire document has been scanned. Furthermore, the way in which
the fax machine is to handle a memory overflow can also be set.
The basic setting for this function can be found on
SEND AFTER
SCAN
. . . . .
page
15-MAR-00 WED
19:56
RESIDUAL MEMORY 100%
15-MAR-00 WED
19:56
RESIDUAL MEMORY 100%
ENTER TEL NUMBER
SEND AFTER SCAN
1.YES
2.NO
WHEN MEMORY FULL
1.DELETE SCAN PAGES
2.SEND SCAN PAGES
RESIDUAL MEMORY 100%
ENTER TEL. NUMBER
131.
Standby mode
Load originalRemember:Printed side
face down
Document ready
Operate the Menu function template
Press the corresponding function key
Make your selection for SEND AFTER SCAN
1. Send during scanning
2. Send after scanning
Select a menu item
In the case of selection 1 (behaviour in the
event of a memory overflow)
1. Cancel sending (document feed ready for
use)
2. Continue sending (documents remain in
the document feed until the memory is
free)
Select a menu item
Dialling the fax partner
57
Advertisement
Table of Contents
