Call Transfer; Three-Way Conference Call; Advanced Function; Click To Dial - New Rock Technologies NRP1000 User Manual

NRP1000 Series IP Phone

3.1.7 Call Transfer

Blind Transfer
During conversion, you can press the Transf key, enter the number to transfer to, and press "#" to
transfer the current call to a third party. After the transfer, you are disconnected with the caller. Note
that you cannot select the SIP line when the call transfer is enabled.
Attended Transfer
To make an attended transfer, press the Transf key, enter the number to transfer to, and press SEND
during the conversion. After the third party answers, press Transf to complete the operation. Note that
to enable this function, you need to enable call waiting and call transfer first.
Alert Transfer
During the conversation, press the key Transf, enter the number to transfer to, and press SEND (the
connection is not established yet). As soon as the call is answered, press Transf to complete the
operation. Note that to enable this function, you need to enable call waiting and call transfer first.

3.1.8 Three-Way Conference Call


Press the Conf key during the conversation.

The first call is placed on hold. Enter the conference ID to join after hearing a dial tone, and press
SEND.

When the call is answered, press Conf and add the first call to the conference.

If you want to leave the conference, press the Split key.
Note: This function operates normally only when your VoIP service provider supports RFC3515. To
enable this function, you need to enable the call waiting function.

3.2 Advanced Function

3.2.1 Click to Dial

When browsing in an appointed Web page, user A can click to call user B via a link (this link to user B),
then user A's phone will ring, after A hooks off, the phone will dial to B.
Note: External software supporting the click to dial function is required.

3.2.2 Auto Answer

If an incoming call is not answered until the answer time expires, the phone enabled with this function
will answer the call automatically.

3.2.3 Hotline

You can set a hotline number for each SIP line in the dialer interface. After Warm Line Time, the
phone will call out the hotline number automatically.
New Rock Technologies, Inc.
User Manual
3-3