Lan; Figure 5-10 Lan Setting Interface - New Rock Technologies NRP1000 User Manual

NRP1000 Series IP Phone
Name
DHCP
PPPoE
After parameter setting, click Apply to validate these parameters.

If you change the IP address, you need to input a new IP address in the address bar so that you

can log in to the phone.
If you use an IP address obtained during the system startup, and the IP address of the DHCP

server is identical with the LAN IP address, the system increases the last octet of the LAN IP
address by 1 and modifies the LAN IP address segment assigned by the DHCP server. If the
system attempts to accesses DHCP services after startup, and the IP address assigned by the
DHCP server is identical with the LAN IP address, the WAN port cannot obtain an IP address
and therefore the phone cannot access the network through the WAN port.

5.4.2 LAN

Figure 5-10 LAN setting interface

Table 5-8 LAN parameters setting
Name
IP Address
Subnet Mask
DHCP Service
NAT
New Rock Technologies, Inc.
Description
Indicates whether to enable the DHCP mode. If you choose this mode, the phone can
obtain the network-related information automatically from the DHCP server
automatically, and no action is required.
Indicates whether to enable PPPoE mode. If you choose this mode, you need to input
the ADSL account and password.
Description
Specifies a static LAN IP address.
Specifies a LAN subnet mask.
Enables the DHCP server of the LAN port. If you modify the LAN IP address, the
phone will automatically modify contents in the DHCP Lease Table according to the IP
address and subnet mask, and then save the modification. To validate the DHCP
service settings, you need to reboot the phone.
Enables NAT.
User Manual
5-9