New Rock Technologies NRP1000 User Manual page 51

NRP1000 Series IP Phone
8T indicates that if the phone is configured with a SIP2 server and has been registered to the server, all
users attempting to make phone calls through the SIP2 server need to add 8 before the phone number
2T indicates that if the phone is configured with a an IAX2 server and has been registered to the server,
all users attempting to make phone calls through the IAX2 server need to add 2 before the phone
number
Note: To compatible with functions in version 1.6, the "Dialpeer With Line:" field is added to the
configuration file of version 1.7 version, indicating whether to enable the on-line inquiry function. 0 for
Disabled and 1 for Enabled. The default value is 0.
Compared with version 1.6, functions added in version 1.7 include: Not enabled on-line inquiry
The function is the same as that in version 1.6.
Type: specifies the protocol on which the rule takes effect.
Destination: specifies the destination IP address.
0.0.0.1: indicates that SIP line 1 is used.
0.0.0.2: indicates that SIP line 2 is used.
0.0.0.x: indicates that SIP line x is used.
(To compatible with codes in earlier versions, 0.0.0.0 indicates that SIP line 1 is used; 255.255.255.255
indicates that SIP line 2 is used.
Configuration examples are as follows:
If the phone dials the number 21111, the call is sent out through SIP line2, with the called number of
1111.
If the phone dials the number 32222, the call is sent out through IAX2, with the called number of 2222.
Enable on-line query capabilities
The precondition for this function is that the phone must have multiple lines, allowing the line and
protocol to be selected before dial-up.
Dialpeer table in the query, the first comparison dialing protocol is selected in the table and dialpeer
agreement, if the same, continue down the match, otherwise, check the next one.
Step match line information, comparing the selected dial-up line is a line in the table and dialpeer is the
same, if the same, continue down the match, otherwise the next query.
The third step is for a prefix or exact match.

Mode: If the mode is set to SIP, this rule takes effect only for SIP-based calls. If the mode is set to
IAX2, this rule takes effect only forIAX2 calls.

Destination: indicates the destination IP address.

0.0.0.1: indicates that this rule takes effect only for calls on SIP line 1.
New Rock Technologies, Inc.
User Manual
5-27