Section 11: Fuel Tank Assembly - Hangar 9 P-40 Warhawk Assembly Manual

Section 10: Two-Stroke Engine Installation

Step 9
Position the throttle servo tray so the opening for
the servo is on the same side of the fuselage as the
throttle pushrod tube. Use Medium CA to glue the
tray into position.

Section 11: Fuel Tank Assembly

Required Parts
• Clunk (fuel pickup)
• Fuel pickup tubing
• Rubber stopper
• Metal tubes (short and long)
• Fuselage assembly
Required Tools and Adhesives
• Hobby knife
• Foam: 1/4"
• Phillips screwdriver (small)
Note: The stopper provided with the P-40
has three holes that are not bored completely
through the stopper. The holes are for the
fuel pickup, fill and vent lines. For these
instructions only, two holes will be used: one
for the fuel pickup and one for the fuel vent.
Only open the third hole if you are going to
use a separate fill line.
30
• Metal caps (2)
• Fuel tank
• M3 x 20 screw
• Fuel tubing
• Masking tape

Step 10
Attach the "Z" bend on the throttle pushrod wire onto the
carburetor arm. Slide the pushrod wire into the tube and
secure the engine to the firewall.

Step 1
Locate the fuel tank parts.