Advertisement
6. System Information and Operation
This chapter covers system general characteristic under normal operation.
IMPORTANT NOTE:
If you operate your alarm system via Connect2Home application, please be reminded that the
SMS command messages sent with Connect2Home application will incur extra cost.
Arming/Disarming the System
To change the modes, you can use the Connect2Home Application or the remote controller.
Away Arm
1. Press the "Arm" button on the Connect2Home application; or
2. Press the "Arm" button on the remote controller.
Home Arm
1. Press the "Home Arm" button on the Connect2Home application; or
2. Press the "Home Arm" button on the remote controller.
After initiating the arming process, the control panel will start counting down (see below) while
emitting small beeps periodically.
Upon finishing the countdown, the control panel will emit small beeps depending on your arm mode:
3 quick beeps for home arming. 1 long beep for away arming.
Exit Delay Timer
After initiating the arming process, the users are given time to exit the premises before the system
is armed.
The exit delay timer is configurable with the Connect2Home application, or through the SMS
command.
Stopping the Exit Timer
You can stop the exit timer before it finishes counting down. To do that, you can either
1. Press the disarm key on the remote controller, or
2. Select disarm on the Connect2Home application, or
Extending the Exit TImer
You can reset the exit timer to its initial duration before it finishes counting down:
1. Press and hold the "Away Arm" or "Home Arm" key on the Remote Controller.
Fault Events
The Control Panel keeps track of the system condition and will alert the user when a fault is detected.
For example: when the door contact is not aligned with the magnet, or when its tamper switch is
activated.
When faults exist in system, the Fault LED will light up to indicate. If the fault exists in the panel, the
Fault LED will stay lit. If the fault exists in a device, the Fault LED will start flashing.
If you have set a mobile number to SMS report for All Event or Status Events, the Control Panel will
also send a SMS message to notify you when fault is detected.
32
Advertisement
