Advertisement
4. System Default Setting
.
Entry/Exit Time and Device Attribute
When the system is armed and an Entry device is triggered, the Entry timer will begin to count down
(default 20 seconds). The system must be disarmed before the timer expires, or a Burglar alarm will
be activated.
When the arming process is initiated, the Exit timer will begin to count down (default 30 seconds),
the system will ignore any sensors triggered during this period. The user should use this duration
to leave the premises before the system is armed.
NOTE: PIR Sensor and Door Contact learny in will be automatically assigned to "Entry" attribute.
For device attribute settingl and Entry/Exit Time programming, please see later chapter – 5.
Connect2Home Application.
Alarm Activation
When an alarm is triggered, the system will report to the programmed telephone numbers
according to the priority. The system can dial the telephone numbers you entered in the system,
play voice message upon connection or send an SMS message.
Address Message
The Address Message will be played in the beginning of all your voice message reports to notify
the recipient of your user information. Please make sure you have recorded your own Address
Message by referring to the previous chapter 3. Getting Started.
Alarm Length
Default alarm length for siren upon activation is set to 3 minutes. To change the alarm length,
please refer to chapter 5. Connect2Home Application.
Jamming and Interference Detection
The Control Panel is capable of detecting signal jamming and interference, the function is disabled
by default, if jamming and interference is of concern to you, please see chapter 5. Connect2Home
Application.
10
Advertisement
