Advertisement
Alarm Memory
If an alarm was raised without being silenced during your absence, the alarm reporting will still be
carried out.
When you come back and disarm the system, the siren will sound for 3-second to warn you that the
intruder might still be inside your house.
Tamper Protection
1. When the system is under Away Arm mode, if a tamper switch is triggered, an alarm will be
activated immediately. The Control Panel will send a SMS alarm event "Tamper" to programmed
SMS report telephone number, or dial the Voice report telephone number and play "Burglar"
message upon answer.
2. When the system is under Home or Disarm mode, the alarm will not be activated. The Control
Panel will send a SMS status event "Tamper" to programmed SMS report telephone number, it
will not dial for Voice report. The fault LED will light up to remind you.
Dialing and Call Acknowledgement
When an alarm is activated, the Control Panel will dial the programmed telephone numbers in priority
order for Voice Message or SMS Message report. When the Control Panel makes Voice Message
Reports:
After dialing, the Control Panel will delay 5 seconds before playing the message. It will first play
the general part of the recorded message (Address) then plays the specific alarm message
(Burglar, Fire, Medical or Emergency) depending on the nature of the alarm.
To ensure the call is successfully received by the recipient, the recipient should acknowledge the
message by pressing the appropriate button on his telephone set.
If the Control Panel does not receive any acknowledgement, the message will be repeated for
85 seconds. The Control Panel will then consider the call unsuccessful and dial the next phone
number in priority.
If more than one number is programmed the Control Panel will continue to dial the number(s)
until a recipient presses the third response key.
If no phone number is programmed, the Control Panel will not dial.
Call Acknowledgement
When the Control Panel makes Voice Report, there are 3 responses available for the recipient to
receive the call, by pressing 1, 0 or 9 key on his telephone set.
Press 1:
The Control Panel will open a one-way listen only channel for 2 minutes for you to listen
to what is happening on the other side.
During the last 20 seconds of the 2-minute period, the Control Panel will sound a beep to
remind the recipient. Press 1 again to extend another 2 minutes.
When the 2-minute period expires, the Control Panel will automatically hang up and dial
the next number.
34
Advertisement
