Advertisement
Force Arm
If you try to arm the system when fault exists, the Control Panel will emit a beep to indicate failure.
You can choose to arm the system anyway and ignore the faults by force arming the system.
For the remote controller, press and hold the away arm/home arm key again, and the Control Panel
will initiate the arming process and begin counting down the Exit Timer
NOTE:
Force Arm is not required for Connect2Home Application. The Control Panel will enter selected
arm mode upon directly and report back a SMS message to remind you of the existing faults
Up to 3 faults can be included in the SMS message.
Disarm
When the system is under Away arm or Home Arm mode, to disarm the system:
1. For Remote Controller, press "Disarm" key
2. For Connect2Home application, simply press the "Disarm" button.
Entry Delay Timer
When a Door Contact or PIR sensor, set to Entry attribute, is triggered, the system will begin an
Entry Delay countdown timer according to Entry Time setting.
The reason for this is to give the users some time to disarm the system when you enter your home.
You need to disarm the system before the timer expires, or a burglar alarm will be activated.
Alarm Activation
1. When a device, previously set to Burglar, is triggered, the alarm will be activated immediately.
2. When a device, previously set to Entry, is triggered, the Entry countdown timer will be activated.
If the system is not disarmed before the timer expires, an alarm will be activated.
3. When a device, previously set to Home Omit, is triggered in Home Arm mode, the device will be
ignored. If the device is triggered in Away arm mode, the alarm will be activated immediately.
4. When the tamper switch of the devices is triggered in Away arm mode, the alarm will be activated
immediately.
5. You can trigger an Emergency alarm with the Remote Controller
Stopping the Alarm
During an alarm, the Control Panel will sound the siren, and report to the programmed telephone
numbers.
To stop the alarm, send a SMS command to disarm the system with Connect2Home application, or
press the Disarm key on your Remote Controller.
NOTE:
Remote Controller cannot be used to stop the Emergercy Alarm triggered by itself.
33
Advertisement
