Advertisement
Record Address Message
The Control Panel is capable of reporting events through SMS message or Voice message.
When Voice Reporting is selected and an alarm is triggered, the Control Panel will dial the
programmed telephone number and play the alarm message upon answer.
The Address Message is the first voice message played at the beginning of every voice message
report to notify the call recipient of the caller's information. The default Address Message is "Alarm
System." You can record your own Address Message through the following steps.
1. Under Disarm mode, press and hold the Function Button for 8 seconds and release when the
Control Panel emits 1 beep.
2. The Control Panel will emit another long beep after 3 seconds to indicate recording is started.
3. Speak clearly and slowly for the Control Panel to record your address message. When you have
finished recording, press the Function Button once to stop recording, or the recording will stop
automatically when it reaches 10 seconds.
4. Recording is now complete, the Control Panel will return to the Disarm mode.
Device Learning
The process of adding devices into the control panel is called "Learning." The control panel needs
to learn in the accessory devices setup a complete alarm system. Please see below for learning
instruction.
NOTE: The devices included in the SA 2500 Kit are already learned into the system. For these
devices, please proceed directly to Mounting section below.
1. Under Disarm mode, press the Function Button once, the Control Panel will emit 1 beep and the
Mode LED will begin to flash to indicate the Control Panel is now under Learning Mode.
2. Under Learning mode, press the learn/test button on your accessory device to transmit a learn
code. (Please refer to the device manual for detail)
3. The Control Panel will emit 1 beep upon receiving the learn code to indicate the device is
successfully learnt in.
4. After learning all devices, press the Function button again. The Control Panel will emit 1 beep,
and the Mode LED will stop flashing and stay lit to indicate it is now under Disarm mode.
5. When you try to learn in a device that was previously learned into the system, the Control Panel
will emit a "Ding Dong" sound.
NOTE: The Learning Mode will time out after 5 minutes. However, whenever the Control Panel
receives a learn code, the 5 minutes timer will be reset.
Device Mounting
After learning devices, you should proceed to mount the devices in select locations in your home.
As you mount the device, you also need to test the device signal range to make sure the device is
within control panel operation range. See below for instruction on device range test and individual
device mounting guideline.
7
Advertisement
