Advertisement
Confirmation Setting
The siren can be enabled or disabled for arming
and disarming confirmation.
When set to Enabled, the Siren will beep
when the system is armed or disarmed to
confirm the mode change.
When set to Disabled, the Siren will not
activate when system mode is changed.
Entry/Exit Setting
The Outdoor Siren and Indoor Siren can be
enabled or disabled from sounding warning
beeps during Entry Time and Exit Time
When set to Enabled, the Siren will beep
during Entry and Exit Time.
When set to Disabled, the Siren will not
beep during Entry and Exit Time.
Learn
Repeater
required)
Use this function to send add the Repeater
device into your alarm system. Put your
repeater into learning mode, the send the SMS
command to the Control Panel. The panel will
transmit signal to Repeater upon receiving the
SMS command. Please refer to Repeater
manual for further detail.
(Optional
Repeater
PSS Control (Optional Power Switch
required)
The Power Switches can be controlled manually
or through Home Automation settings to turn
on/off you home appliance remotely to monitor
your home environments.
PSS Learning:
1. Put the Power Switch into Learning mode
(Please refer to Power Switch manual for
detail)
2. Select Learning in the Action option on your
Connect2Home application, Press "Save" to
confirm. Press "Send" to send the SMS
command to panel.
3. The control panel will transmit signal to the
power switch
The power switch LED will flash 3 times upon
receiving signal from Control Panel to indicate
learning is now complete.
PSS Control:
Select the channel you want to edit, then
choose to turn on/off the Power Switch.
Press "Save". A SMS message edit screen
will appear for you to confirm.
"Send" to send the SMS command to panel.
20
Press
Advertisement
