Programming The Panorama Function; Programming The Position Hold Time During Panorama Mode - videotronic SN-15AH PPHS Mounting And Operation Instructions

MOUNTING AND CONNECTING
-

Programming the panorama function:

The panorama function allows a tour through all preset camera positions in a pre-
determined cycle. Camera positions 01 - XX will be called one after the other. The
highest position number in the cycle can be programmed with the KB-485 keyboard.
Following entries are possible:
1. Store highest position number (xx)
(last position of the cycle)
Enter: "P XX L/P" (Panorama P 01 - P xx)
2. Start panorama function:
"PAN
Enter:
3. Stop panorama function:
Enter:
Strike any key to stop the panorama function.
-

Programming the position hold time during panorama mode

1. Stop the pan/tilt unit by hitting any cursor key (up, down, left right)
Enter: "T xx" (xx = idle time in seconds x 2,5)
Examples:
5 seconds hold time: "T02
10 seconds hold time: "T04
To re-start the panorama function enter "^B" and the pan/tilt head will immediately
start with position 01. After the position has been reached, the programmed hold
time starts. Then the head will be moving to the next position, and so on.
"
-21-