Mounting The Camera Station - videotronic SN-15AH PPHS Mounting And Operation Instructions

MOUNTING AND CONNECTING

Mounting the Camera Station

Attention When installing the camera station please make sure to follow the order
mentioned below.
1. Install the pan/tilt motor to a Videotronic WA-40BSN wall bracket using the
attached installation material (M6 x 20 hex / M6 nut/ M6 washer).
2. Fix the service junction box incl. power supply unit as near to the motor as
possible. The pre-wired connections of the motor have a length of 2,5 metres and
have to be connected to the service junction box after installation.
3. Fix the VI "System Camera" unit to the bracket of the motor using the attached
screws. The camera can also be mounted upside down, depending on the
application.
4. When connecting the system cable, see correct polarity of the cable (PIN 1 =
transparent). Further details are mentioned in the operating instructions of the
system camera. After having installed the system camera, please fix the lateral
covers to the bracket of the motor using 2 screws (M3 x 8).
26-pin system connector (camera connection)
1 heater +
2 heater -
3 lanc signal
4 linelock GND
5 +12 V DC
6 linelock
7 GND
8 video
9 zoom +
10 zoom -
11 focus +
12 focus -
13 GND
14 backlight
15 Y signal
16 C signal
17 NC
18 NC
19 auto focus
20 shutter
21 PP +
22 PP -
23 zoom position
24 focus position
25 current loop
26 current loop
-7-