Table of Contents
Advertisement
MOUNTING AND CONNECTING
Pre-set call via alarm inputs (switch 12 / DIP I)
The P/T unit can also be controlled via control (alarm) inputs over the RS485 interface.
With these control inputs you can call pre-set camera positions from the memory. The
contact numbers of the control inputs (1-64) are directly assigned to the corresponding
position number (1-64).
If you want to transfer the alarm of a camera station to a connected VIDEOTRONIC
video matrix, switch 12 (DIP I) has to be set to position ON. The video matrix must have
the system address „00" since only this address can process the alarm message of the
camera station. For further information, please ask for the corresponding operating
instructions.
switch 12
Change from (F)BAS to Y/C operation (switch 5 and 6 /DIP II)
switch 5
switch 6
switch 7
switch 8
Activating current loop / RTS, CTS (RS-232)
switch 9
switch 10
switch 11
switch 12
When supplied from the factory, current loop and RTS, CTS of the RS-232 interface are
not active (switch 9 -1 2 at position OFF).
alarm message adr. 00
On
RS-485 active
Off
RS-485 not active
F(BAS) mode
On
Off
On
Off
current loop / RTS, CTS (RS-232)
active
Off
Off
Off
Off
Y/C mode
Off
On
Off
On
not active
On
On
On
On
-15-
Advertisement
Table of Contents
