Table of Contents
Advertisement
MOUNTING AND CONNECTING
Selection of correct payload (switch 09 and 10 / DIP I)
The P/T unit is designed for a max. payload of 15 kg. In order to guarantee an optimum
start drive for the used camera, you can select between "≤ 5 kg", "> 5 kg" and "≤ 5 kg /
tracking mode" camera load.
Switch 9
Off
On
Off
The unit comes factory set with a payload of "≤ 5 kg". This corresponds to the
videotronic Vitect camera housing.
Control via RS-485 is not possible in tracking mode.
Software: switch 11 / DIP I
Switch 11
To activate the software for RS-232 or RS-485 control, please set switch 11 (DIP I) as
shown in the above table. Please make sure that among software settings, also the
hardware settings have to be changed accordingly.
Hardware: switch 1 - 4 / DIP II
To change the hardware settings, use switches 1-4/DIP II as shown in the table below.
The factory setting is RS-485 active.
switch 1
switch 2
switch 3
switch 4
Switch 10
Off
Off
On
Interface
On
RS-232
Off
RS-485
RS-485
Off
On
Off
On
Weight
≤ 5 kg
> 5 kg
≤ 5 kg /
tracking mode
RS-232
On
Off
On
Off
-14-
Advertisement
Table of Contents
