Table of Contents
Advertisement
MOUNTING AND CONNECTING
Configuring the camera station for tracking mode
In order to configure the camera station it is necessary to remove both lateral parts of
the PTZ head for getting access to both DIP blocks on the control circuit board.
Software: switches 9 - 11 / DIP1
For altering the software the switches 9-11 have to be set according to the table shown
below.
Switch 9
Switch 10
Off
On
≤ 5 kg /
tracking mode
For activating the software for RS-232 control switch 11 (DIP 1) has to be set according
to the table shown below.
Switch 11
Interface
On
RS-232
For this mode the following interface parameters are valid:
19,200 Baud, 1 start / stop bit, no parity, 8 data bits, no handshake
Please note that hardware and software have to be set.
Hardware: switches 1 - 4 / DIP 2
-17-
Advertisement
Table of Contents
