Elba E74-200 Instructions For Use - Installation Advice page 28

7
7
IMPORTANT: Installation has to be
carried out according to the instruc-
tions provided by the manufacturer.
Incorrect installation might cause
harm and damage to people, ani-
mals or objects, for which the man-
ufacturer accepts no responsibility.
DET ILS
Connection to the electric power sup-
ply must be carried out by a qualified
technician and following the appropri-
ate safety regulations.
Before carrying out the connection to
the power supply, the voltage rating
of the appliance (indicated on the
appliance rating plate) must be
checked for correspondence to the
available mains supply voltage, and
the mains electric wiring should be
capable of bearing the hob power rat-
ing (also indicated on the rating plate).
The appliance is supplied without a
power supply plug and therefore if
you are not connecting directly to the
mains, a standardized plug suitable
for the load must be fitted (gas mod-
els only).
The power supply must be connected
to a suitable earth wiring, in conformi-
ty to current safety regulations.
The colours of the wires in the hob
power cable may not correspond with
the colours marked on the terminals
of your electrical plug. The plug
should in any case be wired as fol-
lows:
– connect the green/yellow wire to the
terminal marked with the letter PE or
the earth symbol or coloured
green/yellow;
– connect the blue wire to the terminal
marked with the letter N or coloured
black;
28
ELECTRIC L SECTION
– connect the brown wire to the ter-
minal marked with the letter L or
coloured red.
It is possible to connect the appliance
directly to the mains by means of a
heavy duty switch with 3 mm mini-
mum distance between the contacts.
The power supply cord must not
touch against any hot surfaces and
must be placed so that its tempera-
ture does not exceed 75°C at any
point along its length.
After having installed the appliance,
the power switch or power plug must
always be in an accessible position.
The appliance must have its own
supply; any other appliances installed
near it must be supplied separately.
– N.B. For connection to the mains
power supply, never use adaptors,
reductions or multiple power points
as these may overheat and catch fire.
In the event that installation should
require modifications to the mains sup-
ply wiring system or if the power plug is
not suitable for the type of power point
available, it is recommended that a qual-
ified technician be called to carry out
substitution.
The technician will also have to verify
that the cross-section of the electric
cables on the power point match the
appliance's power rating.
Connection to a good earth wiring
system is absolutely essential.
The manufacturer accepts no
responsibility for any inconve-
nience caused by failure to comply
with this rule.