Elba E74-200 Instructions For Use - Installation Advice page 20

CHOOSING SUIT BLE
SURROUNDINGS
(for gas models)
The room where the gas appliance is to
be installed must have a natural flow of
air so that the gas can burn (in compli-
ance with the current laws in force).
The flow of air must come directly from
one or more openings made in the
outside walls with a free area of at least
2
100 cm .
If the appliance does not have a no-
flame safety device this opening must
have an area of at least 200 cm
The openings should be near the floor
and preferably on the side opposite the
exhaust for combustion products and
must be so made that they cannot be
blocked from either outside or inside.
When these openings cannot be made,
the necessary air can come from an
adjacent room which is ventilated as
required, as long as it is not a bedroom
or a danger area (in compliance with the
current laws in force).
In this case, the kitchen door must allow
the passage of the air.
Extractor hood for
products of
combustion
Air vent
Fig. 5.6
20
Installation technicians must comply
to current laws in force concerning
ventilation and the evacuation of
exhaust gases.
Intensive and prolonged use may
require extra ventilation, e.g. opening
a window, or more efficient ventila-
tion increasing the mechanical suc-
tion power if this is fitted.
DISCH RGING PRODUCTS
OF COMBUSTION
Extractor hoods connected directly to
2
.
the outside must be provided, to allow
the products of combustion of the gas
appliance to be discharged (fig. 5.6).
If this is not possible, an electric fan may
be used, attached to the external wall or
the window; the fan should have a
capacity to circulate air at an hourly rate
of 3-5 times the total volume of the
kitchen (fig. 5.7).
The fan can only be installed if the room
has suitable vents to allow air to enter,
as described under the heading
"Choosing suitable surroundings" (in
compliance with the current laws in
force).
Electric fan to
extract products of
combustion
Fig. 5.7
Air vent