Manual AutoGap Settings
AutoGap Set to Single
When AutoGap is set to Single, the printer sets the gap between the
printhead and the paper only once. This should only be used when
printing on several cut sheets of the same thickness while using the Auto
Sheet Feeder. The printer adjusts the printhead to the paper's thickness
when you turn the printer on or when the paper select lever is changed.
There are two Single AutoGap options:
• Open (factory default) means that the printhead moves out of the way
• Fixed means that once the gap is set, the printhead does not move.
50
Chapter 3: Using the Operator Panel
Paper
Paper
Type
Thickness
Single Forms
Thin
(Single Sheets or
Continuous Forms)
Normal
Thick
Multiple-Part Forms
__
When the setting is
4 or higher,
printing speed
becomes slower.
Envelopes
as each sheet of paper is loaded. This setting reduces paper jams.
Manual
Weight of Paper
Setting
2
45.1 g/m
(12 lb)
1
2
56.25 g/m
(15 lb)
2
67.5 g/m
(18 lb)
1 or 2
2
75 g/m
(20 lb)
2
90 g/m
(24 lb) 2
2 Part Form
2 or 3
3 Part Form
3 or 4
4 Part Form
4 or 5
5 Part Form
5 or 6
6 Part Form
5, 6, or 7
4, 5, or 6