Adding Available Options In The Print Driver; Networking; Preparing To Set Up The Printer On An Ethernet Network - Lexmark CS417 User Manual

Additional printer setup
3
For Macintosh users, add the printer.
Note: Obtain the printer IP address from the TCP/IP section in the Network/Ports menu.

Adding available options in the print driver

For Windows users
1
Open the printers folder.
2
Select the printer you want to update, and then do the following:
•
For Windows 7 or later, select Printer properties.
•
For earlier versions, select Properties.
Navigate to the Configuration tab, and then select Update Now ‑ Ask Printer.
3
4
Apply the changes.
For Macintosh users
1
From System Preferences in the Apple menu, navigate to your printer, and then select Options & Supplies.
2
Navigate to the list of hardware options, and then add any installed options.
3
Apply the changes.

Networking

Notes:
•
Purchase a MarkNet
network. For information on installing the wireless network adapter, see the instruction sheet that came
with the adapter.
•
A Service Set Identifier (SSID) is a name assigned to a wireless network. Wired Equivalent Privacy (WEP),
Wi-Fi Protected Access (WPA), WPA2, and 802.1X - RADIUS are types of security used on a network.

Preparing to set up the printer on an Ethernet network

To configure your printer to connect to an Ethernet network, organize the following information before you
begin:
Note: If your network automatically assigns IP addresses to computers and printers, continue on to installing
the printer.
•
A valid, unique IP address for the printer to use on the network
•
The network gateway
•
The network mask
•
A nickname for the printer (optional)
Note: A printer nickname can make it easier for you to identify your printer on the network. You can
choose to use the default printer nickname, or assign a name that is easier for you to remember.
TM
N8352 wireless network adapter before setting up the printer on a wireless
26