1. DESCRIPTION OF THE MAIN COMPONENTS
1.1. Vehicle
1.1.1. Design of the vehicle
•
32 mm tube frame, homologated as per CIK-FIA Standards 2003
Frame geometry especially developed for the RM1Kart
•
40 mm rear axle
•
New design MAGURA 4-disk brake system, homologated as per CIK-FIA 2003 Standards
•
Manually adjustable brake force distribution
•
New design stub axle with adjustable wheel track width
•
Stub axle with adjustable caster and camber
•
Adjustable pedals
•
Closed pedals
•
Adjustable stabilizer (rear)
•
TILLET seat
•
Alcantara coated steering wheel
•
7.5 litres / 2,0 gal. fuel tank
•
MOJO D1/W1 tires
•
Aluminium rims with bead retaining screws
The ROTAX RM1Kart was developed and homologated according to the latest CIK (Commission
Internationale de Karting) homologation regulations for 2003.
The following components have the homologation numbers mentioned below:
Chassis:
105/CH/08
Fairing parts:
25/CA/08
Brake system:
92/FR/08
1.1.2. Fairings
The fairing parts of the ROTAX RM1 Kart are of
special scratch proof and flexible material. The
parts therefore are much more resistant in case
of collisions usual in Kart sports.
The surface is finished using a sublimation
technique, the design is protected by a transparent
coating against damage (scratches, ... )
All fairing parts are homologated as per CIK – FIA
Standards 2003.
These fairings do not need replacing as often as similar products.
Seite/page 70/132
Operator`s Manual RM1
ROTAX KART RM1
Ausgabe/Edition 01/2006