Change Of Gear Oil - Rotax RM1 Operator's Manual

4.14.

Change of gear oil

During the first 5 operating hours wear is highest. For this reason the gear oil must be changed
after the first 5 operating hours (and then after every 50 operating hours).
Proceed as follows:
Open the oil drain screw (pos. 2).
Collect the drained oil in a suitable
container.
Note: Dispose
according to the regulations of
your country.
Clean the oil drain screw.
Fit the oil drain screw and tighten it
with 20 Nm (177 lb. in.).
Open the oil refill screw (pos. 1).
Fill in 0,25 l (0.066 gal.) of motor oil of quality SAE 15 W 40.
Check the oil level at the inspection glass.
Hand tighten the oil refill screw (pos.1)
Attention: Never use the engine without
motor oil, this would damage the
engine.
Seite/page 109/132
Operator`s Manual RM1
of the old oil
ROTAX KART RM1 Ausgabe/Edition 01/2006