Chapter 7; Chipper Accessories; Extended Top-Discharge Chute; Installation - DR RAPID-FEED 16.50 PRO Safety & Operating Instructions Manual

CHAPTER 7

CHIPPER ACCESSORIES

SHUT DOWN THE ENGINE, WAIT FOR ALL MOVING PARTS TO COME TO A COMPLETE STOP, REMOVE
SPARK PLUG WIRE, DISCONNECT THE NEGATIVE BATTERY CABLE, THEN WAIT 5 MINUTES BEFORE
PERFORMING ANY MAINTENANCE PROCEDURE, ADDING OPTIONAL ACCESSORIES OR INSPECTION
ON THE CHIPPER.

Extended Top-Discharge Chute

The Extended Top-Disc
and allows you to d and allows you to d
Tools Needed Tools Needed : :
• •
Two 1/2" W Two 1/2" W nches
INSTA INSTA LLATION LLATION
1. 1. Remove the tw Remove the tw
Discharge Assemb Discharge Assemb
47). 47).
2. Remove the Low D 2. Remove the Low D
Chipper. Chipper.
3. Position th 3. Position th
Chipper wit Chipper wit
furt furt hest away from hest away from
4. Install the tw 4. Install the tw
two 1/2" wre two 1/2" wre
p-Disc harge Chute enables you to better control the directio harge Chute enables you to better control the directio
irec irec t them into a trailer or truck bed for transport. t them into a trailer or truck bed for transport.
re re nches
o Bolts a o Bolts a nd Locknut nd Locknut
ly with two 1/2" wrenches (Figure ly with two 1/2" wrenches (Figure
ischarge Assembly from the ischarge Assembly from the
e Extended e Extended Top-Discharge Chute onto the Top-Discharge Chute onto the
h the Locking pin on the outside (side h the Locking pin on the outside (side
the hopper) (Figure 48). the hopper) (Figure 48).
o Bolt o Bolt s and Locknuts and tighten with s and Locknuts and tighten with
nches. nches.
CONTACT US AT www.DRpower.com or CALL TOLL FREE 1-800-DR-OWNER
s from the Low s from the Low
n of the discharged chips n of the discharged chips
Bolt and
Locknut
Figure 47
Bolt and
Locknut
(2 places)
Figure 48
Low
Discharge
Assembly
Extended Top-
Discharge Chute
Locking
Pin
51