Operation - Superior DRL4543TEN Installation And Operation Instructions Manual

Removing Exterior Glass Door
1. Using a flat head screw driver, pop out
the top and bottom trim pieces as shown
in Figure 37.
2. Remove 8 screws at top and bottom of
glass door and remove glass door.
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance is equipped with an igni-
tion device which automatically lights
the pilot. Do not light pilot by hand.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
C. Do not use this appliance if any part
has been under water. Immediately call
a qualified service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
26
FIREPLACE INSTALLATION
Continued

OPERATION

www.SuperiorFireplaces.US.com
Trim
Figure 37 - Removing Exterior Glass
Door for Cleaning
LIGHTING
INSTRUCTIONS
NOTICE: During initial operation
of new fireplace, burning will
give off a paper-burning smell.
Orange flame will also be pres-
ent. Open window to vent smell.
This will only last a few hours.
1. STOP! Read the safety information in
column 1.
2. Turn off all electric power to fireplace.
3. Turn safety shutoff switch to the OFF
position.
4. Remove center brick/control cover.
5. Turn equipment shutoff valve clockwise
to the OFF position (see Figure
38, page 27). Do not force.
6. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the
floor. If you smell gas, STOP! Follow "B"
in the safety information. If you don't smell
gas, go to the next step.
7. Turn equipment shutoff valve counter-
clockwise
not force.
8. Replace center brick/control cover.
9. Turn on all electric power to appliance.
Trim
Screws
to the ON position. Do
126718-01A