Superior DRL4543TEN Installation And Operation Instructions Manual page 22

3. Make sure control knob of fireplace is in
the OFF position.
4. Check all joints from equipment shutoff
valve to gas valve (see Figure 24 or
Figure 25, page 21). Apply noncorrosive
leak detection fluid to all joints. Bubbles
forming show a leak. Correct all leaks at
once.
5. Light fireplace (see Operation, page 26).
Check all other internal joints for leaks.
6. Turn off fireplace (see To Turn Off Gas to
Appliance, page 27).
FINISHING FIREPLACE FOR
INSTALLATION
(V)LDV43 series fireplace come with the rear
panel semi-installed. If you will be using the
fireplace for a one sided regular application,
you will need to finish the installation of the
rear panel. If you will be upgrading the fire-
place to a see-thru, the rear panel will need to
be removed (See Upgrading (V)LDV43 Series
to See-Thru Application page 23).
1. Using self-tapping screws provided and
holes on rear panel as a guide, screw
the rear panel to the fireplace as shown
in Figure 26.
Figure 26 - Installing Rear Panel for
Regular Applications
Discontinue use of the appliance
immediately if doors are damaged and
contact a qualified installer for repair.
Only doors certified with the appliance
shall be used.
22
FIREPLACE INSTALLATION
Continued
www.SuperiorFireplaces.US.com
REMOVING/REPLACING GLASS
DOOR
CAUTION: Do not operate
this fireplace with a broken glass
door panel or without the glass
door panel securely in place.
Only doors certified with the appli-
ance shall be used.
CAUTION: Wear gloves and
safety glasses while handling
or removing broken glass.
Do not remove if glass is hot.
Keep children and pets away
from glass.
WARNING: If fireplace has
been running, turn off fireplace.
Let cool before removing glass
doors.
Removing Glass Door
If replacement of glass is necessary, the entire
frame assembly must be replaced. Gloves
must be worn when removing/replacing glass
door. If glass is broken tape remaining glass
onto frame before removing.
1. Remove bottom access panel.
2. Unlock 3 door latches on top of firebox
using your fingers or the latch opener
provided.
3. Hook opener over latch as shown in Fig-
ure 27. Swing the bottom of the opener
down toward the door. You will not need
to pull down.
4. Tilt open glass door 45° from the top of
firebox and lift up to release door from
retaining channel (see Figure 28, page 23).
Figure 27 - Latch Opener
126718-01A