Superior DRL4543TEN Installation And Operation Instructions Manual page 32

MODES OF OPERATION
Operation modes:
• MANUAL OFF
• MANUAL ON
The modes may be cycled in the order above
by pressing the MODE Zone or the MODE/
SET Button.
MANUAL OFF MODE
• Transmits flame OFF command.
• LCD Displays:
• MODE Zone: OFF is displaye
• ROOM TEMP Zone: Measured
temperature is displayed
• SET TEMP Zone: Blank
• LIGHT Zone: LIGHT and light set-
ting level is displayed
• FAN Zone: Blank
• TIME/PROG Zone: Current day
indicator and current time is dis-
played
• AUX Zone: Blank (AUX function is
omitted on this control)
• FLAME Zone: Blank
MANUAL ON MODE:
• Transmits flame ON command
• LCD Displays:
• MODE Zone: ON is displayed
• ROOM TEMP Zone: Measured
temperature is displayed
• SET TEMP Zone: Blank
• LIGHT Zone: LIGHT and light set-
ting level is displayed
• FAN Zone: FAN and fan setting
level is unused
• TIME/PROG Zone: Current day
indicator and current time is dis-
played
• AUX Zone: Blank (AUX function is
omitted on this control)
• FLAME Zone: A&B Flame Icons
and flame setting level numbers
are displayed
FLAME - A (OR MAIN) ADJUSTMENT
• Transmits a flame height setting com-
mand to the control module to adjust the
Flame-A height.
• Available settings are 1-7 with a factory
default of 7. If the Flame-A setting is
32
REMOTE CONTROL OPERATION
www.SuperiorFireplaces.US.com
Continued
changed during operation (either manu-
ally or automatically), the control will re-
member and use the adjusted setting on
subsequent manual ON cycles (Flame-A
setting memory).
• While in MANUAL ON, or PROGRAM
ON modes, press the FLAME Zone to
enter Flame-A Adjustment, then press
the UP or DOWN buttons to raise and
lower the flame; press the MODE/SET
Button or wait for 15 seconds to accept
the new setting.
• LCD Display: When setting the Flame-A
height, the Flame-A icon, and Flame-A
setting number will flash in the FLAME
Zone.
LIGHT ADJUSTMENT
• Transmits a light setting command to
the control module to adjust the light
output level.
• Available settings are 0 (off) – 6 with a
factory default of 0 (off).
• While in any mode of operation, press
the LIGHT Zone to enter Light Adjust-
ment, then press the UP or DOWN
buttons to raise or lower the light output;
press the MODE/SET Button or wait for
15 seconds to accept the new setting.
• LCD Displays:
• When raising or lowering the light
output level with the UP or DOWN
buttons, the light icon and light
setting number will flash in the
LIGHT Zone.
CONTINUOUS PILOT OPERATION
• To activate or deactivate the Continuous
Pilot Feature, press and hold the MODE/
SET and UP Buttons simultaneously for
5 seconds.
• LCD Display: When activated, CONT. PI-
LOT will be displayed in the MODE Zone.
CHILD-LOCK OPERATION
• Child-Lock operation prevents any user
input to the transmitter. No mode of op-
eration or feature may be adjusted when
Child-Lock is activated. All automatic
functions will continue normally.
• To activate or deactivate the Child-Lock
feature, press and hold the MODE/SET
and DOWN Buttons simultaneously for
5 seconds.
126718-01A