Superior DRL4543TEN Installation And Operation Instructions Manual page 23

Replacing Glass Door
1. Position door frame in front of firebox
opening tilting top of door about 45° to-
ward you. Insert bottom flange of glass
door into the retaining channel at the
bottom of firebox (see Figure 28). Make
sure door is center with firebox opening.
2. Tilt top of door up toward top of firebox.
3. Secure 3 top door latches.
Glass
Door
Figure 28 - Removing/Replace Glass Door
GLOWING EMBERS AND GLASS
PEBBLE INSTALLATION
WARNING: Do not change
or substitute glass pebbles
provided with this fireplace. If
replacing, use only replacement
glass pebbles. See Replacement
Parts page 33.
WARNING: Do not block pilot
ports with embers.
Glowing embers and glass pebbles are in-
cluded with your fireplace. Install these items
while glass doors are open and/or removed.
1. Place glass pebbles in a single layer
evenly on the pebble pan. Make sure not
to place any on the burner in the center
of the pebble pan or on the pilot.
2. Pull glowing ember material apart into
pieces no larger than a dime. Place these
pieces loosely and sparingly directly onto
exposed burner ports. This will create
the glowing ember appearance as flame
126718-01A
FIREPLACE INSTALLATION
Door Latches
www.SuperiorFireplaces.US.com
Continued
touches ember material. Do not block air
slots by using too much ember material
in one area. Do not block pilot ports with
embers. It is not necessary to use all of
the glowing ember material provided.
UPGRADING (V)LDV43 TO SEE-THRU
APPLICATION
Removing Rear Panel
1. In the rear of the fireplace, locate screws at
top of rear panel and remove as shown in
Figure 29. Discard screws and rear panel.
2. Unscrew mount bracket from top face as
shown in Figure 30. Discard mounting
bracket and replace screws.
Figure 29 - Removing Rear Panel for
See-Thru Applications
Figure 30 - Removing for See-Thru
Applications
23