Superior DRL4543TEN Installation And Operation Instructions Manual page 25

Side
Filler
Retaining
Bracket
Flange on
Face Bottom
Figure 34 - Access Door for See-Thru
Applications
UPGRADING (V)LDV43 TO INDOOR/
OUTDOOR SEE-THRU APPLICATION
WARNING: LDSTI must be in-
stalled before installing LDSTO.
Installing Exterior Door
1. Center and level exterior door on rear
face of the see-thru fireplace. Exact di-
mensions for the location of the door are
shown in Figure 35.
2. Using self tapping screws (provided)
secure exterior door to the face of the
fireplace by drilling through holes on
door into the fireplace face (Figure 36).
11 5/8"
Figure 35 - Installing Exterior Door for See-Thru In/Out Application
126718-01A
FIREPLACE INSTALLATION
Continued
Access
Door
11 5/8"
www.SuperiorFireplaces.US.com
You may chose to drill pilot holes into the
face using a 1/8" drill bit. Do not use self
tapping screws, use any #10 x 1/2" screw.
3. In locations of extreme weather, it is rec-
ommended to apply a bead of high tem-
perature sealant around the edge where
the exterior door meets the fireplace face.
NOTE: When finishing the face of the exterior
side of the fireplace, use only non-combustible
materials. You may extend up to the edge of
the exterior door covering up the screws used
for installation.
Figure 36 - Installing Exterior Door for
See-Thru In/Out Application
11 5/8" 11 5/8"
1 19/32"
Fireplace
Face
Exterior Door
1 3/16"
3 1/2"
10 1/2"
10 1/2"
2 31/32"
25