Inspecting Burners; Cleaning And Maintenance - Superior DRL4543TEN Installation And Operation Instructions Manual

Check pilot flame pattern and burner flame
patterns often.
PILOT ASSEMBLY
The pilot assembly is factory preset for the
proper flame. Alterations may have occurred
during shipping and handling. The pilot is
located on right hand side of burner.
The flame must envelope 1/4" of top of the
ignitor/sensor and grounding stem.
If your pilot assembly does not meet these
requirements:
• Turn the adjustment screw marked PILOT
clockwise to decrease or counterclockwise
to increase the flame to proper size (see
Figure 39). Do not remove the adjustment
screw.
• see Troubleshooting, page 34
BURNER FLAME PATTERN
Burner flames will be steady, not lifting or float-
ing. Flame patterns will be different from unit
to unit and will vary depending on installation
type and weather conditions.
If the vent configuration is installed incorrectly,
flames will lift or "ghost". This can be danger-
ous. Inspect flames after installation to ensure
proper installation and performance.
WARNING: Turn off fireplace
and let cool before cleaning.
CAUTION: You must keep
control areas, burners and
circulating air passageways of
fireplace clean. Inspect these
areas of fireplace before each
use. Have fireplace inspected
yearly by a qualified service
person. Fireplace may need
more frequent cleaning due to
excessive lint from carpeting,
bedding material, pet hair, etc.
28

INSPECTING BURNERS

CLEANING AND MAINTENANCE

www.SuperiorFireplaces.US.com
If burner flame pattern differs from that de-
scribed:
• turn fireplace off (see To Turn Off Gas to
Appliance), page 27
• see Troubleshooting, page 34
Figure 39 - Correct Pilot Flame Pattern
GLASS DOORS
WARNING: Handle glass
door panels with care. Do not
strike, slam or otherwise abuse
glass. Do not operate fireplace
with the glass door unlatched,
removed, cracked or broken.
WARNING: Do not use
abrasive cleaners as this may
damage glass. Use a nonabra-
sive household glass cleaner to
clean glass. Do not clean glass
when hot.
Glass must be cleaned periodically. During
start-up it is normal for condensation to form
on the inside of the glass causing lint, dust and
Pilot
Burner
126718-01A