Remote Control Operation - Superior VRL4543ZEN Installation And Operation Instructions Manual

Unvented (vent-free) linear gas fireplaces

Hide thumbs

Table Of Contents

Table of Contents

NOTE: The module must be programmed to the Remote Control

transmitter.

•

To program the module (make sure the system has power),

locate the learn button on left side as shown in Figure 27, Page

15. Press and release the learn button. There will be a beep

sound from the module. Then press any button on the remote

transmitter. Once the module's internal receiver accepts the

transmitter code, there will be a series of confirming beeps.

•

The remote system is ready for use.

This remote control system was developed to provide a safe, reliable,

and user-friendly remote control system. The system can be operated

manually from the transmitter.

The transmitter operates with (4) AAA 1.5V batteries that are included.

Install the batteries supplied with the unit into the battery compart-

ment. It is recommended that ALKALINE batteries always be used

for this product. Be sure the batteries are installed with the (+) and

(-) ends facing the correct direction.

When you start up the remote, if a low battery signal appears or if

the LCD screen does not illuminate when you touch it, check battery

position and if the batteries are fully charged.

TOUCH SCREEN LCD AND BUTTON LAYOUT

Functional Description

NOTE: All function adjustments will be automatically accepted 15 -

seconds after pressing a given touch zone or button. The user may

press the MODE/SET button to immediately accept the adjustment

manually.

Day and Time Display

•

The current day of week and time of day will be continuously dis-

played in the TIME/PROG Zone (except during Setup operations).

•

The day of week will be displayed as one of the following: S,

M, T, W, T, F, S

•

The time of day will be in 12-hour AM, 12-hour PM format.

Midnight will be displayed as 12:00am.

•

Day/Time Setup:

•

Press and hold the MODE Zone or the MODE/SET Button

for 5 seconds to enter Day/Time Setup.

•

Press the UP or DOWN Buttons to adjust the day of week

(press the MODE/SET Button or wait for 15 seconds for ad-

justment to be accepted, then enter hour of day adjustment).

•

Press the UP or DOWN Buttons to adjust the hour of the

day. The time will advance in 1-hour increments; AM and

PM will change when the hour advances to 12:00 midnight

and 12:00 noon respectively (press the MODE/SET Button

or wait for 15 seconds for adjustment to be accepted, then

enter minute of hour adjustment).

•

Press the UP or DOWN Buttons to adjust the minute of the

hour. The time will advance in 1-minute increments (press

the MODE/SET Button or wait for 15 seconds and the

transmitter will exit Day/Time Setup and return to normal

operation).

•

LCD Displays – when in Day/Time Setup:

GAS CONTROL MODULE SYSTEM

NOTE: Make sure the valve module and light module are plugged

into the electric duct assembly.

BATTERY BACK-UP

This fireplace is equipped with a battery back-up. If the power was

to go out on the fireplace, the battery back-up allows the fireplace to

remain operational. Make sure to periodically check the condition of

the four AA batteries used for the battery back-up.