6: Basic Troubleshooting and Chassis Service
Hard Drive Carrier Assembly Usage
44
Figure 6-1
Remove Drive and Carrier from Front of Server
1.
Remove the four screws securing the dummy/bad drive to the hard drive carrier.
2. Insert a new/replacement hard drive into the carrier with the PCB side facing down and the
connector end toward the rear of the carrier.
3. Align the hard drive in the disk drive carrier so that the mounting holes of the carrier are
aligned with the mounting holes of the drive. Note that there are holes in the carrier which
are marked "SATA" to aid in correct installation.
007-5841-001