Table of Contents
Advertisement
6: Basic Troubleshooting and Chassis Service
Hard Drive Carrier Assembly Usage
46
Figure 6-1
Remove Drive and Carrier from Front of Server
1.
Remove the four screws securing the dummy/bad drive to the hard drive carrier.
2. Insert a new/replacement hard drive into the carrier with the PCB side facing down and the
connector end toward the rear of the carrier.
3. Align the hard drive in the disk drive carrier so that the mounting holes of the carrier are
aligned with the mounting holes of the drive. Note that there are holes in the carrier which
are marked "SATA" to aid in correct installation.
4. Secure the drive to the carrier with four screws. Use the M3 flat-head screws included in the
HDD bag of your accessory box. Note: the screws used to secure a dummy drive to the
carrier should not be used to secure the hard drive.
007-5839-001
Advertisement
Table of Contents
