Table of Contents
Advertisement
Co-linear terminal confi gurations
10"
10"
7-5/8" dia.
collar
3" Inlet & Exhaust
Collars
559CLT Co-Linear Terminal
Installer—READ THIS FIRST
Only qualifi ed licensed or trained personnel
should install this appliance.
1. YOU NEED TO KNOW FROM THE
HOMEOWNER:
- The height of the fl oor or hearth fi nish;
- The thickness and type of the wall fi nish
around the fi rebox opening;
- What accessories (surround, door, etc.) will
be installed with this fi replace if any;
- The venting confi guration.
2. Unpack the appliance.
3. Check that you have everything.
4. Finish framing.
5. Fit appliance into framing.
6. Remove overlay and fi x the appliance to the fl oor.
7. Reinstall the overlay.
8. Install venting system.
9. Install restrictor.
10. Connect and test gas supply.
11. Install bricks and logs.
12. Refi t window.
13. Connect electrical wiring for decorative light.
14. Install optional wall switch if required.
15. Put batteries in receiver and remote control
handset.
Co-Linear Venting
559FSK Flashing Kit
Installation Planning
Alternate to 559CLT/559FSK Conversion
Terminal Cap
16. Perform initial remote control set-up.
17. Verify operation and adjust aeration settings.
18. Install the remote control handset wall holder.
19. Instruct the homeowner on the operation and
maintenance of the fi replace.
20. Install the window skirt.
21. Install the control access doors.
22. Install the andirons and fret if required.
23. Finish the wall around the fi replace.
24. Install the surround/doors/mantel if required.
QUALIFIED
INSTALLER
Co-Linear to Co-Axial
Adapter
Flashing
33
Advertisement
Table of Contents
