Window Refi Tting And Checking; Remote Control Initial Set-Up - Valor Retrofire RF24IDN Installation And Owner's Manual

Hook the window over the top edge of the fi rebox, and
fasten the bottom two spring loaded bolts by pushing
in and turning 90 degrees. Check that the window
moves freely against the spring by pulling out at the
bottom. If broken, the window may only be replaced as
a complete unit as supplied by the manufacturer.
Note: To remove the window, the optional bottom
cover or the cast iron fret and fret retainers will
need to be removed fi rst—see sections Optional
Cast Iron Fret Installation or Optional Bottom Cover
Installation.
The receiver and the handset of the remote control
system must be initially synchronized before the fi rst
use.
1. Insert alkaline batteries in the remote control
receiver and handset. The receiver is located left of
the control valve under the burner module.
2. With a sharp object, press and hold the receiver's
reset button until you hear one short and one long
beeps. Release the reset button after the second
beep.
3. Within the subsequent 20 seconds, press the small
fl ame button ( ) on the remote handset until you
hear two short beeps confi rming the sychronization
is set.
This is a one time setting only and is not required when
changing the batteries in the remote receiver. The
remote control system is now ready to use.
Window Refi tting and Checking

Remote Control Initial Set-up

Check that Window
Moves Freely After
Reinstallation
Spring Loaded
Fastening Studs (2)
1/4 Turn
17