Table of Contents
Advertisement
1. To refi t the window, hook its top part to the fi rebox's
opening frame. Make sure that the wider part of
the window frame is at the bottom.
2. While you hold it, push in and turn the two top
spring-loaded bolts a quarter turn to engage their
pin.
3. Push in the bottom of the window against the fi rebox
and fasten the two bottom spring-loaded bolts a
quarter turn.
4. Then, pull out the top and bottom of the window and
release it to insure the springs return it.
5. Apply light hand pressure against the window frame
sides to bed-in the window seal.
The receiver and the handset of the remote control sys-
tem must be initially synchronized before the fi rst use.
1. Insert alkaline batteries in the remote control
receiver and handset. The receiver is located left of
the control valve under the burner module.
2. With a sharp object, press and hold the receiver's
reset button until you hear one short and one long
beeps. Release the reset button after the second
beep.
3. Within the subsequent 20 seconds, press the small
fl ame button (
) on the remote handset until you
hear two short beeps confi rming the sychronization
is set.
This is a one time setting only and is not required when
changing the batteries in the remote receiver. The
remote control system is now ready to use.
Window Refi tting
Remote Control Initial Set-up
Bottom
of window
(wider frame)
INSTALLATION
19
Advertisement
Table of Contents
