Remote Control Initial Set-Up; Operation Check And Aeration Adjustment - Valor Retrofire RF24IDN Installation And Owner's Manual

QUALIFIED
INSTALLER
The receiver and the handset of the remote control
system must be initially synchronized before the fi rst
use.
1. Insert alkaline batteries in the remote control
receiver and handset. The receiver is located left of
the control valve under the burner module.
2. With a sharp object, press and hold the receiver's
reset button until you hear one short and one long
beeps. Release the reset button after the second
beep.
3. Within the subsequent 20 seconds, press the small
fl ame button ( ) on the remote handset until you
hear two short beeps confi rming the sychronization
is set.
This is a one time setting only and is not required when
changing the batteries in the remote receiver. The
remote control system is now ready to use.
Turn the fi replace up and down using the remote control to confi rm
that the full range of inputs is achieved.
Light the fi re and allow to warm up for 10–15 minutes to evaluate
the fl ame picture. The burner is equipped with an adjustable air
shutter to control primary aeration. See fi gures below. The shutter is
factory-set at an aeration gap, which will give optimum performance
for the vast majority of installations. In a few unusual installations,
fl ame picture may be improved by adjusting the aeration. The need
for adjustment should be determined only by operating the appliance
with the ceramic fuel effects and window installed.
Increasing aeration will cause the fl ame to appear more
transparent and blue making the ceramic fuel effects
glow more.
Decreasing aeration will cause the fl ames to appear
more yellow or orange making the fuel effects glow less.
Too little aeration may result in black carbon
forming and dropping into the fi rebox.
28

Remote Control Initial Set-up

Operation Check and Aeration Adjustment

Air Shutter Components
Air Shutter in
Open Position
Air Shutter
Air Shutter Retainer
Air Shutter in
Closed Position