Window Refi Tting; Remote Control Initial Set-Up - Valor LEGEND 739ILN Owner's Manual

1. To refi t the window, place the window against the
fi rebox's opening frame. Make sure that the wider
part of the window frame is at the bottom.
2. While you hold it, push in and turn the two bottom
spring-loaded bolts a quarter turn to engage their pin.
3. Push in the top of the window against the fi rebox and
fasten the two top spring-loaded bolts a quarter turn.
IMPORTANT: To ensure a safe operation, ensure that
the bolts are hooked properly to the window tabs.
4. Then, pull out the top and bottom of the window and
release it to insure the springs return it.
5. Apply light hand pressure against the window frame
sides to bed-in the window seal.
6. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
The receiver and the handset of the remote control sys-
tem must be initially synchronized before the fi rst use.
1. Insert alkaline batteries in the remote control
receiver and handset. The receiver is located left of
the control valve under the burner module.
2. With a sharp object, press and hold the receiver's
reset button until you hear one short and one long
beeps. Release the reset button after the second
beep.
3. Within the subsequent 20 seconds, press the small
fl ame button ( ) on the remote handset until you
hear two short beeps confi rming the sychronization
is set.
This is a one time setting only and is not required when
changing the batteries in the remote receiver. The
remote control system is now ready to use.
Window Refi tting
Hot Glass Plate

Remote Control Initial Set-up

Bottom
of window
(wider frame)
QUALIFIED
INSTALLER
29