Fixture Settings; Fixture Information - ProLights ELFIN FC User Manual

3.14 FIXTURE SETTINGS

It is possible to change the parameter value in the following way:
Setting projector functions
• Press the button MENU, set the desired parameter using UP/DOWN and press the button ENTER to
confirm the setting.
- [DIMMER CURVE] - Adjusting the dimmer. Enter in [DIMMER CURVE] to select specific dimming curve.
Particularly when set:
• [MODE1]: The increase in light intensity is linear
• [MODE2]: Light intensity control is finger at low levels and coarse at high levels.
• [MODE3]: Light intensity control is finger at high levels and coarse at low levels.
• [MODE4]: Light intensity control is finger at low levels and high levels and coarse at medium
levels.
- [BLACKOUT] - Blackout function. Select [YES] or [NO] if want, respectively, enable or disable the
function.
- [PAN INVERSE] - Reverse PAN movement. Select [YES] or [NO] for normal/inverted control of the PAN
function
- [PAN INVERSE] - Reverse TILT movement. Select [YES] or [NO] for normal/inverted control of the TILT
function
- [AUTO TEST] - test device. In [AUTO TEST] the unit will run self-test.
- [BACK LIGHT] - Back light display. Select [ON] or [OFF]if want, respectively, enable or disable the back
light display function.
Reset functions
• Press the button MENU so many times until the display shows [PRO DEFAULTS], then press the button
ENTER.
• Select [YES] to reset the default values.
3.15 INFORMATION

Fixture information

• Press the button MENU, set the desired parameter using UP/DOWN and press the button ENTER to
confirm the setting.
- [FIRMWARE VERSION] - Through the FIRMWARE VERSION function you can display the software version
of the device.
- [TEMP] - Through the TEMP function you can display the temperature of the projector.
- [FIXTURE TIME] - Through the FIXTURE TIME function you can display the running time of the projector.
ELFIN FC/VW
23