Operation In Automatic Mode; Music Mode; Sensitivity Microphone Function; Master/Slave Mode - ProLights ELFIN FC User Manual

3.4 OPERATION IN AUTOMATIC MODE

If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
• Press the button MENU so many times until the display shows [SHOW MODE], then press the button ENTER.
• Press the button UP/DOWN to switch between the programs (SHOW1 - SHOW2 - SHOW3 - SHOW4). The unit
will operate in automatic mode.
NOTE - In automatic mode the unit will be set as Master.

3.5 MUSIC MODE

In music mode, via its integrated microphone, the unit can be controlled by music with a clear rhythm in
the bass range. If the music control should not work optimally, increase the volume or reduce the distance
between the sound source and the light effect unit.
• Press the button MENU so many times until the display shows [SOUND STATE], then press the button ENTER.
• Press the button UP/DOWN to select [ON] or [OFF] to enable or disable the sound mode.

3.6 SENSITIVITY MICROPHONE FUNCTION

Select this function to set the value of the sensitivity of the microphone for use with a music control:
• Press the button MENU so many times until the display shows [SOUND SENSE], then press the button ENTER.
• Press the button UP/DOWN to select the desired value (000 - 100).

3.7 MASTER/SLAVE MODE

This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press the button MENU so many times until the display shows [SLAVE MODE] and press the button ENTER.
• Press the button UP/DOWN to select the different modes of operation [SLAVE1] (normal) or [SLAVE2] (light
show)then press the button ENTER.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 16).

3.8 LINKING

Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
ELFIN FC/VW
13