Fixture Settings; White Calibration; Fixture Test - ProLights LUMIPIX6Q User Manual

3.13 FIXTURE SETTINGS

It is possible to change the parameter value in the following way:
Dimmer
• Enter in Dimmer mode to select specific dimming curve, press the button MENU so many times
until shows [DIMMER MODE], and press the button ENTER to confirm.
• Press the button UP/DOWN to select [MODE 1 - MODE2 - MODE3].
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
Standby
• To activate Blackout function, press the button MENU so many times until shows [STANDBY], and
press the button ENTER to confirm.
• Press the button UP/DOWN to select [YES].
• Press ENTER button to confirm.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
Back Light
• To activate Backlight display press the button MENU so many times until shows [BACK LIGHT], and
press the button ENTER to confirm.
• Press the button UP/DOWN to select [ALL - 10S - 20S - 30S].
• Press ENTER button to confirm the selection.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically.
Back Dimmer
• To activate Backlight intensity, press the button MENU so many times until shows [BACK DIMMER], and
press the button ENTER to confirm.
• Press the button UP/DOWN to select the value [0 - 100].
• Press ENTER button to confirm the selection.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically.

3.14 WHITE CALIBRATION

Enter the White balance to adjust the RGB parameter to make different whites.
• Press the button MENU so many times until shows [WHITE BALANCE], and press the button ENTER to con-
firm.
• Select red, green or blue (R - G - B), through the buttons UP/DOWN.
• Press MENU button to confirm.
• Set the value 000-255, through the buttons UP/DOWN.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu automati-
cally.

3.15 FIXTURE TEST

Auto Test
Allow checking the proper functioning of the unit. Start the automatic test in the following way:
LUMIPIX6Q
15