Manual Mode; Service Function - ProLights ELFIN FC User Manual

24

3.16 MANUAL MODE

It is possible to change the parameter value in the following way:
ELFIN FC
Manual control
• Press the button MENU so many times
until the display shows [MANUAL TEST], then
press the button ENTER.
• Press the button UP/DOWN to select the
function to be adjusted between: [PAN],
[TILT], [RED1/2/3/4], [GREEN1/2/3/4], [BLUE1/2/3/4],
[WHITE1/2/3/4], [DIMMER] and [STROBE], then
press ENTER button to confirm the choice.
• Set the desired parameter [000 - 255] using
the UP/DOWN button and press the ENTER
button to confirm the setting.
• Press the MENU button to go back or wait
some seconds for automatic exit from the
menu.
Reset
• Press the button MENU so many times until the display shows [RESET], then press the button ENTER
to reset the projector.
Home position adjustment
To set the corrective value (offset mode):
• Press the button MENU.
• Press and hold the ENTER button for about 3 seconds.
• Select the desired function through the button UP/DOWN, then press the ENTER button to confirm
the choice.
• Set, by using UP and DOWN buttons, the new value for the function, then press the ENTER button
to confirm the choice. The possible values range for each function is reported in the following table:
OFFSET
3.17 SERVICE FUNCTION ELFIN FC
It is possible to change the value of calibration in the following way:
Calib.c
• Press the button MENU so many times until the display shows [WHITE BALANCE], then press the button
ENTER.
• The setting can be changed by acting on the value [125 - 255] relating to the red [RED], green [GREEN],
and blue [BLUE].
ELFIN FC/VW
ELFIN VW
Manual control
• Press the button MENU so many times
until the display shows [MANUAL TEST], then
press the button ENTER.
• Press the button UP/DOWN to select the
function to be adjusted between: [PAN],
[TILT], [COOL WHITE], [WARM WHITE], [DIMMER]
and [SHUTTER], then press ENTER button to
confirm the choice.
• Set the desired parameter [000 - 255] using
the UP/DOWN button and press the ENTER
button to confirm the setting.
• Press the MENU button to go back or wait
some seconds for automatic exit from the
menu.
PAN OFFSET
TILT OFFSET
127 ··· -127