Removing And Replacing The Endo Assembly - Motorola D10 Service Manual

Level 1 and 2 Service Manual

Removing and Replacing the Endo Assembly

G
G
6809464A58
4. Lift the top end of the antenna cover away from the phone. Be careful not to
damage the lanyard loop at the top end of the phone.
5. To replace, align the antenna cover to the phone.
6. Attach the top end of the antenna cover to the top of the phone.
7. Press the bottom end of the antenna cover until it locks into place.
8. Replace the battery and battery cover as described in the procedures.
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
The housing is fastened with plastic catches. These are delicate and should be parted
using utmost care.
1. Remove the battery cover, battery, SIM, and antenna cover as described in the
procedures.
2. Use the disassembly tool to release the 4 latches located on the sides of the
phone as shown in Figure 8.
Latches
Endo Assembly
Figure 8. Removing the Endo Assembly
May 20, 2003
Disassembly
Latches
23