SiBE18-821_C
To set the flaps or louvers at desired position
• This function is effective while flaps or louvers are in auto swing mode.
Press
desired position.
• In the 3-D airflow, the flaps and louvers move in turn.
• "
" or "
CAUTION
• Always use a remote controller to adjust the angles of the flaps and louvers. If you attempt to
move it forcibly with hand when it is swinging, the mechanism may be broken.
• Always use a remote controller to adjust the louvers angles. In side the air outlet, a fan is
rotating at a high speed.
NOTE
Note on the angles of the flaps
• The flaps swinging range depends on the
operation. (See the figure.)
Note on 3-D airflow
• Using 3-D airflow circulates cold air, which
tends to collected at the bottom of the room,
and hot air, which tends to collect near the
ceiling, throughout the room, preventing
areas of cold and hot developing.
Operation Manual
and
when the flaps or louvers have reached the
" disappears from the LCD.
In DRY operation or
COOL operation
COMFORT AIRFLOW
5˚
15˚
Upper limit
40˚
Lower limit
Stop operation
In HEAT operation
Stop operation
15˚
Upper limit
55˚
Lower limit
and COMFORT AIRFLOW
In FAN operation
5˚
Upper limit
55˚
Lower limit
RA Indoor Unit
Stop operation
207